Pegboard Double-Prong Hook — Extra-Thick and Heavy-Duty, Featuring Superb Load-Bearing Capacity

L:100/150/200/250/300/350/400(mm)

Core Advantages

    Dual-Prong Structure: Two parallel prongs insert simultaneously into the pegboard, sharing the load while restricting hook rotation, maintaining directional orientation during use.

    Extra-Thick Material: Hook wire or sheet thickness exceeds that of standard comparable products, reducing bending deformation after prolonged heavy loading.

    Load Capacity: Within the specified length range, the hook maintains a horizontal position and supports corresponding retail product weights without permanent bending.

    Length Coverage: Increments of 50mm from 100mm to 400mm cover thin bagged items to thicker or grouped heavy products.

Product Features

The product is offered in seven length options: 100mm, 150mm, 200mm, 250mm, 300mm, 350mm, and 400mm. Installation is achieved by inserting both prongs simultaneously into standard pegboard holes (common hole diameters of 5mm or 6mm, depending on version). The two prongs are arranged in parallel with fixed spacing. The single-prong arm design is suitable for products with single or double hanging holes. The hook tip features an upward bend or anti-drop ball end (depending on batch). Hook material is extra-thickened, with thickness parameters determined by load requirements. Surface finishes include electroplating or powder coating, selectable based on environmental requirements.

Application Scenarios

    Hardware retail stores for heavy hand tools, wrench sets, hammers, saw blades, and other heavier items with hanging holes.

    Automotive parts stores for oil filter carded displays, car tool kits, trailer accessories, and tie-down straps.

    Industrial or warehouse retail environments for chains, pipe clamps, cable reels, and small-batch heavy parts.

    Home or garage areas for heavy garden tools, extension cord reels, and outdoor equipment accessories.

Common Questions and Solutions

Question: Both prongs cannot be inserted simultaneously into the pegboard.
Possible cause: Mismatch between the prong spacing and the pegboard hole center-to-center distance, or bent/deformed prongs. Confirm that the pegboard hole spacing matches the hook version, and check that the prongs are straight.

Question: The hook loosens or rotates after insertion.
Possible factor: Pegboard hole diameter exceeds the prong diameter, or prongs are worn. Replace with a pegboard that has standard hole diameters, or select a hook version with a larger prong diameter.

Question: The hook tip lowers under heavy load.
Possible factor: The load exceeds the recommended capacity for that specific length, or the material thickness is insufficient for the applied weight. Select a shorter hook length or use multiple hooks to distribute the load.

Related Precautions

    Verify that the pegboard hole diameter and hole spacing match the dual-prong parameters before installation. Mismatches may cause insertion failure or instability.

    The recommended load per hook should not exceed 80% of the tested limit to maintain hook tip horizontal alignment and structural integrity.

    Clean with a soft cloth and neutral detergent. Avoid abrasive materials or strong acid/alkali cleaners.

    Not suitable for products without hanging holes or for products with hanging hole spacing that does not match the dual-prong center distance.