Pegboard Single-Prong Hook — Strong Load-Bearing Capacity, Stays Securely in Place

L:100/150/200/250/300/350/400(mm)

Core Advantages

    Installation Stability: The hook tail includes dual prongs or an anti-rotation structure that forms a tight fit with the pegboard hole, reducing rotation or displacement when loading merchandise.

    Load Capacity: Within the specified length range, the hook maintains a horizontal position and supports corresponding retail product weights without permanent bending.

    Corrosion Resistance: The surface is coated with an anti-oxidation layer, providing rust resistance in standard indoor retail environments.

    Length Coverage: Increments of 50mm from 100mm to 400mm cover thin bagged items to thicker boxed or grouped products.

Product Features

The product is offered in seven length options: 100mm, 150mm, 200mm, 250mm, 300mm, 350mm, and 400mm. Installation is achieved by inserting dual prongs or a single prong with stabilizing structure into standard pegboard holes (common hole diameters of 5mm or 6mm, depending on version). The single-prong design is suitable for bagged, boxed, or carded products with hanging holes. The hook tip features an upward bend or anti-drop ball end (depending on batch). Surface finishes include electroplating or powder coating, selectable based on environmental requirements. The tail structure is designed to reduce rotational movement and loosening during use.
Application Scenarios

    Hardware retail stores for hanging hand tools, screwdrivers, pliers, tape measures, and similar carded or bagged items.

    Kitchen or home goods stores for spatulas, ladles, oven mitts, cleaning brushes, and other products with hanging holes.

    Garage or storage areas for garden tools, extension cords, and small equipment accessories.

    Convenience store or supermarket checkout-adjacent areas for carded merchandise such as batteries, tape, and small tools.

Common Questions and Solutions

Question: The hook rotates or tilts after insertion into the pegboard.
Possible cause: Mismatch between the anti-rotation structure of the hook tail and the pegboard hole diameter, or incomplete insertion. Confirm that the pegboard hole diameter (5mm or 6mm) matches the hook version, and push the hook until the prong base contacts the pegboard surface.

Question: The hook tip lowers slightly when merchandise is loaded.
Possible factor: The load exceeds the recommended capacity for that specific length. Select a shorter hook length or distribute heavier items across multiple hooks.

Question: The hook loosens or is easily pulled out of the pegboard.
Possible cause: Deformed prongs or worn/enlarged pegboard holes. Replace with a new hook of the same specification, or replace the pegboard section. For twist-lock pegboard systems, check whether the rear locking tab is missing.

Related Precautions

    Verify that the pegboard hole diameter matches the hook prong diameter before installation. Mismatches may cause instability or insertion failure.

    The recommended load per hook should not exceed 80% of the tested limit to maintain hook tip horizontal alignment.

    Clean with a soft cloth and neutral detergent. Avoid abrasive materials or strong acid/alkali cleaners.

    Not suitable for products without hanging holes or with significantly off-center balance, such as spherical items or irregular packaging with a heavy bottom.