Pegboard Single-Prong Hook — Extra-Thick, High-Load Capacity, Secure & Stable

L:100/150/200/250/300/350/400(mm)

Core Advantages

    Extra-Thick Material: The wire or sheet material thickness of the hook exceeds that of standard comparable products, reducing bending deformation after prolonged heavy loading.

    Installation Stability: The dual-prong tail structure forms a tight fit with the pegboard holes, maintaining directional orientation and controlling rotation during use.

    Load Capacity: Within the specified length range, the hook maintains a horizontal position and supports corresponding retail product weights without permanent bending.

    Length Coverage: Increments of 50mm from 100mm to 400mm cover thin bagged items to thicker or grouped heavy products.

Product Features

The product is offered in seven length options: 100mm, 150mm, 200mm, 250mm, 300mm, 350mm, and 400mm. Installation is achieved by inserting dual prongs into standard pegboard holes (common hole diameters of 5mm or 6mm, depending on version). The single-prong design is suitable for bagged, boxed, or carded products with hanging holes. The hook tip features an upward bend or anti-drop ball end (depending on batch). The hook material is extra-thickened, with thickness parameters determined by load requirements. Surface finishes include electroplating or powder coating, selectable based on environmental requirements. The tail anti-rotation structure is designed to reduce rotational movement and loosening during use.

Application Scenarios

    Hardware retail stores for heavy hand tools, hammers, wrenches, socket sets, and other heavier items with hanging holes.

    Automotive parts stores for oil filter carded displays, car tool kits, trailer hitch accessories, tie-down straps, and similar products.

    Industrial or warehouse retail environments for chains, pipe clamps, cable reels, and small-batch heavy parts.

    Home or garage areas for heavy garden tools, extension cord reels, and outdoor equipment accessories.

Common Questions and Solutions

Question: The hook rotates or fails to maintain horizontal orientation after insertion into the pegboard.
Possible cause: Mismatch between the anti-rotation structure of the hook tail and the pegboard hole diameter, or deformation of one of the dual prongs. Confirm that the pegboard hole diameter matches the hook version (5mm or 6mm), and check that the prongs are straight and undamaged.

Question: The hook tip lowers under heavy load.
Possible factor: The load exceeds the recommended capacity for that specific length, or the material thickness is insufficient for the applied weight. Select a shorter hook length, use two hooks to distribute load, or reduce the number of items per hook.

Question: The hook loosens or becomes detached from the pegboard.
Possible cause: Deformed prongs, worn or enlarged pegboard holes, or incomplete insertion. Replace with a new hook of the same specification, or push the hook until the prong base contacts the pegboard surface. For twist-lock pegboard systems, check that the rear locking tab is properly engaged.

Related Precautions

    Verify that the pegboard hole diameter matches the hook prong diameter before installation. Mismatches may cause instability or insertion failure.

    The recommended load per hook should not exceed 80% of the tested limit to maintain hook tip horizontal alignment and structural integrity.

    Clean with a soft cloth and neutral detergent. Avoid abrasive materials or strong acid/alkali cleaners.

    Not suitable for products without hanging holes, products with significantly off-center balance, or items exceeding the yield strength of the hook material.