Supermarket/Retail Grid Panel Double-Wire Load-Bearing Hook

L:100/150/200/250/300/350/400(mm)

Core Advantages

    Extra-Thick Wire: Wire diameter exceeds that of standard comparable products, reducing bending deformation after prolonged heavy loading.

    Dual-Bar Support Structure: Two parallel metal bars share the load, resulting in lower point contact stress compared to single-hook designs, suitable for wide hanging holes or flexible packaging.

    Installation Stability: The tail design matches the mesh grid hole dimensions, maintaining directional orientation and controlling lateral movement during use.

    Length Coverage: Increments of 50mm from 100mm to 400mm cover products of varying widths and thicknesses.

Product Features

The product is offered in seven length options: 100mm, 150mm, 200mm, 250mm, 300mm, 350mm, and 400mm. Installation is achieved by inserting the tail into mesh grid openings or securing via back-clip (depending on version). The parallel dual-wire structure is suitable for products with dual holes or wide hanging openings, as well as bagged or flexible packaging. Wire thickness is extra-thickened, with diameter determined by load requirements. The bar ends feature an upward bend or anti-drop bend (depending on batch), with both bars treated identically. Bar spacing is fixed. Surface finishes include electroplating or powder coating, selectable based on environmental requirements.

Application Scenarios

    Hardware or tool retail stores for heavy hand tools, tool sets, extension cord reels, and safety equipment.

    Automotive parts stores for oil container hangers, rolled tool kits, tow straps, and fire extinguisher brackets.

    Industrial or warehouse retail environments for chains, tie-down straps, pipe clamps, and cable reels.

    Outdoor or sporting goods stores for backpacks, sleeping bags, camping tools, and folding chairs.

Common Questions and Solutions

Question: One of the two bars shows bending deformation.
Possible factor: Uneven load concentrated on a single bar, or the vertical projection of the merchandise weight deviates from the center of the dual-bar assembly. Adjust the merchandise center of gravity to sit between the two bars, or use a shorter hook length.

Question: Merchandise swings excessively between the two bars.
Possible cause: Mismatch between the bar spacing and the product hanging hole width. Measure the hanging hole width and select a hook version with closer spacing, or add a retaining accessory to the hanging hole.

Question: The hook loosens on the mesh grid.
Possible cause: Mismatch between the tail design and the mesh grid hole dimensions, or incomplete engagement. Confirm that the mesh grid hole spacing matches the hook version, and check that the tail is fully inserted or clipped in place.

Related Precautions

    Verify that the mesh grid hole spacing matches the hook tail design before installation. Mismatched grid specifications may cause insecure attachment.

    The total load per hook should not exceed 80% of the tested limit to maintain parallel bar alignment and structural integrity.

    Clean with a soft cloth and neutral detergent. Avoid abrasive materials or strong acid/alkali cleaners.

    Not suitable for products without hanging holes or for products with hanging hole width exceeding 1.5 times the fixed bar spacing.